Skateboard deck, skateboard grip tape, razor blade or box cutter and file are only the matters you must adequately apply grip tape on your longboard. These steps for the application of tape are: sector 9 deck • Detach the paper on the grip tape. This will expose the sticky surface. •You need to use the piece of the backing paper to hold the surface of the tape to protect your hands from the sticky area. •Slice the grip tape slightly greater than the board by analyzing its midpoint. You can let the grip tape hang on a bit in the focal area of the board. This is to make sure that the tape within the board will stick during the middle firstly. Once the tape has stuck in the center of the board, you will need to make sure that you carefully stick close to the sides along with the very same goes from your middle going onwards. Keep in mind that you need to handle this carefully because this is really sticky. loaded longboards •Use a metal file or else a metal beam of a screwdriver, so that you can scratch in the region of the boundaries of the longboard skateboard deck. Ensure that you rub firmly till the time all the grains are vanished. You additionally really need to make sure that you can see a white line visible and this must be witnessed as well within the grip tape to benefit finding out the board’s limits. •You can sue the razor blade or cutter to remove all the excess grip tape by positioning it on a 45 degree angle and cut from the base upwards. You need to make sure that you begin on the tail or now. After that follow the white outline and run the blade in along the edge of the skateboard longboard deck eliminating additional grip tape. visit this website •In order to level the uneven edges, rush a metal file approximately within the edges of the longboard.•Lastly, make use of a screwdriver in order to push holes all the way through the grip tape wherever the trucks would be accumulated.